This topic has been archived. It cannot be replied.
-
枫下家园 / 电脑电信 / 网速衰减问题光纤Modem/Router1上网,每次在modem上测速(buildin)可以稳定达到100%+(额定),用Powerline (500MB)连到另一个Router2(当Hub用),Ethernet连接电脑,每次在电脑上测速(fast.com),速度只有额定的1/4到1/2, 无线连接测速最高可以达到3/4. 为什么Ethernet连接会这么慢?
-5678b(Summer);
2018-6-18
{253}
(#11588273@0)
-
Powerline 500MB 是理想的上限,就算接收就在发射旁边也未必能达到。如果距离远,再加上2个circuit breaker 的衰减就更不要说了
-canadagoose(楓中秋雁);
2018-6-18
(#11588422@0)
-
衰减一点可以理解,问题是衰减到只有500MB的1/30多,i.e. 只有15MB左右。。。
-5678b(Summer);
2018-6-19
(#11588916@0)
-
Shouldn't be that bad, is it directly connected to power socket?
-starw(starwar);
2018-6-19
(#11589001@0)
-
Yes, both ends directly connected to power socket. I should test to connect PC to power line directly bypass the router2. Will post after back to home at night.
-5678b(Summer);
2018-6-19
(#11589023@0)
-
新问题:PC的Ethernet一连到Powerline, 就断掉,接回Router2网络就通,奇了怪了...
-5678b(Summer);
2018-6-19
(#11590028@0)
-
你不是说 "单测过powerline" 吗?那个单测和这个有什么区别?
-canadagoose(楓中秋雁);
2018-6-20
(#11590153@0)
-
是啊,上周日我把Powerline 两个端对调,大的(3口)连Modem/Router1,小的(单口)PC, 测速可以达到满速,所以觉得Powerline没问题。所以又把Powerline两端换回来,小的(单口)连Modem/Router1,小的(3口)连Router2. 这个是不是有讲究?
-5678b(Summer);
2018-6-20
(#11590269@0)
-
刚才又把大小端对调,发现问题所在。似乎Powerline有”方向性“,现在大的(3口)连Modem/Router1,小的(单口)连Router2, PC Ethernet测速可以达到1/2到3/4左右。
-5678b(Summer);
2018-6-20
(#11591244@0)
-
以上是单机测速(PC), Router2再开一Laptop测速,速度基本各减半,这正常吗(注Wireless全部disable, 只测试Ethernet)?
-5678b(Summer);
2018-6-20
(#11591274@0)
-
这太正常了,LAN内互联设备的网速是switch > router > hub,hub本身就是带宽共享的,若有5台电脑连上去那每台只有hub全速的1/5而已....你这个家庭小LAN可能需要重新设计一下,比如用两台router无线接力wifi信号或用有线方式连接,其它尽量用switch不要用hub...
-see1see(Isee);
2018-6-20
(#11591356@0)
-
powerline还要看产品质量,有不少其实连接和速度的稳定性不见得好,能不用尽量不用。用高速网线有线连接两台router是最能保障速度的,虽然拉线可能麻烦一点或辛苦一点,但还是很值得的...
-see1see(Isee);
2018-6-20
(#11591365@0)
-
Good idea! 准备研究一下两台router无线接力wifi信号
-5678b(Summer);
2018-6-21
(#11591694@0)
-
不是泼你冷水,我用过两台刷西红柿的router,效果一般,真不如powerline稳定。记住,power 最好不要插在插线板上,要插在墙上的插座上。
-winterfish(潜水鱼(\ (•◡•) /));
2018-6-21
(#11593220@0)
-
两端都是插墙上。今天测无线可以到满速,但我的两Router都没有WDS, 如何无线接力?!
-5678b(Summer);
2018-6-22
(#11594088@0)
-
Ethernet is 1/2到3/4 of speed between adapter is reasonable
-starw(starwar);
2018-6-20
(#11591291@0)
-
为什么要掉来掉去?router 2 那边 需要很多接口?
-canadagoose(楓中秋雁);
2018-6-20
(#11590473@0)
-
对,当时光纤线不好进Basement, 只好进厨房,再Powerline进Basement, 主要电脑都在Basement, 需要很多接口。
-5678b(Summer);
2018-6-20
(#11591246@0)
-
need reset if you do not know how, disable then enable ethernet adapter
-starw(starwar);
2018-6-20
(#11591306@0)
-
did many times for switching Ethernet and wifi. Thought to delete it and recreate it, but unable to delete. Don't know why?
-5678b(Summer);
2018-6-20
(#11591493@0)
-
无线和powerline 永远达不到有线网线的稳定和速度
-canadagoose(楓中秋雁);
2018-6-18
(#11588425@0)
-
现实是无线测速稳定并快与有线,点解?
-5678b(Summer);
2018-6-19
(#11588918@0)
-
只能说明你的有线网络环境有问题
-akoei(停车**枫林晚);
2018-6-19
(#11589896@0)
-
是啊,现在就是诊断问题在哪里
-5678b(Summer);
2018-6-19
(#11590029@0)
-
这。。。不就是在电力线上吗。。。不信就拉根网线对比测试
-akoei(停车**枫林晚);
2018-6-20
(#11591139@0)
-
对,问题逐渐清晰。见上。
-5678b(Summer);
2018-6-20
(#11591229@0)
-
换个switch试试。。。
-ding_ding(丁_丁);
2018-6-19
(#11589985@0)
-
powerline本质上也是个modem,其编码解码抗干扰等等本身就有衰减,何况后面又接一个router,速度瓶颈就在powerline......
-see1see(Isee);
2018-6-18
(#11588452@0)
-
单测过powerline,它达到额定上限(光纤Modem 60Mbps)没问题。速度瓶颈好像在Router2. 不知道做哪些设置可以提速?
-5678b(Summer);
2018-6-19
(#11588927@0)
-
你的Router2只支持到802.11 b协议?
-xjcjq(rufeng);
2018-6-19
(#11589178@0)
-
b/g/n都支持
-5678b(Summer);
2018-6-19
(#11590034@0)
-
你的Router2只是做hub,没有设置。如果加了hub网速下降,那就是hub的问题
-canadagoose(楓中秋雁);
2018-6-19
(#11589806@0)
-
改用switch代替router,或许问题就迎刃而解了
-see1see(Isee);
2018-6-20
(#11590188@0)
-
需要拉网线
-columbus(Edgar);
2018-6-19
(#11588557@0)
-
我用过一段时间Powerline Adapter, 现在已经进垃圾桶了。网速很慢而且经常断网。还是无线Wifi 用得比较顺,买个Wifi USB Adaptor 就搞定。
-madog(武疯子);
2018-6-19
(#11588919@0)
-
我用的tp Link还不错,跟网线直连差不多,电视盒子连电力猫很稳定。
-winterfish(潜水鱼(\ (•◡•) /));
2018-6-20
(#11590241@0)
-
我的是D-Link
-5678b(Summer);
2018-6-20
(#11590272@0)
-
Router2 不要当HUB用,而是做为下级router,多一跳,但是比当hub会好些,试试吧。
-winterfish(潜水鱼(\ (•◡•) /));
2018-6-19
(#11589977@0)
-
这样设置比较麻烦,二级IP都要变,无线漫游不知怎么设
-5678b(Summer);
2018-6-19
(#11590037@0)
-
拿router当hub用是下下策,为何不用switch呢?现在才几刀一个
-see1see(Isee);
2018-6-20
(#11590185@0)
-
他要用router 的WiFi功能做roaming,这个要看每个router的具体设置。
-winterfish(潜水鱼(\ (•◡•) /));
2018-6-20
(#11590240@0)
-
为什么?当switch用是二层,怎么会比三层的路由慢
-akoei(停车**枫林晚);
2018-6-20
(#11591140@0)
-
为了省事儿,直接买mesh router 得了。
-ontario_2014(rolian);
2018-6-20
(#11590246@0)
-
太贵了
-5678b(Summer);
2018-6-20
(#11590277@0)
-
可不可以先试试 powerline 1 和 2 插在同一个A/C (简单没有闪电保护的)接线板上,看看速度有多快。这样可以知道家里电线和circuit breaker 的衰减有多少然后在basement 安装一个A/C电源插座连到电箱里面powerline 1 的线路,powerline2 就插到这个插座上。这样传输就不用经过2个circuit breaker的衰减。不过你要查查是否违反building code。
-canadagoose(楓中秋雁);
2018-6-21
{174}
(#11591654@0)
-
powerline 1 和 2 插在同一个A/C基本没衰减,但安装插座太麻烦。准备研究无线接力(免安装免投资)
-5678b(Summer);
2018-6-21
(#11591774@0)
-
那么 circuit breaker 就是衰减的原因了
-canadagoose(楓中秋雁);
2018-6-21
(#11592402@0)
-
突然又想起,powerline表现最好是同一条电源线一串到底,中间若通过多条电源线及多个插座的转接,会影响速度(估计是解码和纠错的开销大).....
-see1see(Isee);
2018-6-21
(#11592894@0)